Syvecs Forums

Posted: **Thu Aug 22, 2013 6:38 pm**

I have a 1jz Supra (This one in fact: viewtopic.php?f=16&t=177)

I need an output form the ECU to interface with my push button / auto start system. Previously I have used the charge output form the alternator however, since changing the alternator this no longer does what I require.

Basically I need an output that changes state once the engine is running, preferably pulled low for stopped & high for running.

This is used to stop the cranking of the engine once its fired up.

I have a spare output - Pin 23 Inj 8 - which I believe can be used as an output.

I need to know how to turn this into the output I need.

Cheers.

Posted: **Fri Aug 23, 2013 11:07 am**

A bit like the starter enable function!

Posted: **Fri Aug 23, 2013 5:56 pm**

Indeed very much like that!

Sadly my firmware is old enough not to have that & I don;t want to get involved with updating it at present.

I had more of a head scratching today & have instead used the G6 alternator charge output & set that to switch off at very low RPM which has provided me with exactly what I require

Posted: **Fri Aug 23, 2013 6:58 pm**

Just update the firmware or get someone to do it for you.

Posted: **Tue Aug 27, 2013 9:58 am**

Already sorted with above method so, no need.

Will mess about with firmware when I have more time to plough through the procedure. Rite now its unnecessary.

Syvecs Forums

Engine running output for auto start to turn off starter.

Engine running output for auto start to turn off starter.

Re: Engine running output for auto start to turn off starter.

Re: Engine running output for auto start to turn off starter.

Re: Engine running output for auto start to turn off starter.

Re: Engine running output for auto start to turn off starter.