Syvecs Forums

I was testing out the connection between my laptop and S6 GP after installing windowz on my linux laptop ready for toucan purchase and E85 mapping later on. I had both sCal and sMon open but realized later on I was in sCal when I think I might have done something stupid.

I had a warning that the coolant temp was low after startup, so I found the remove all warnings feature and proceeded. After that I went and changed the launch control strategy and programmed the ECU. After then looking at the errors again it struck me that maybe what I had actually done was removed all warning levels for the cal, not reset the warnings.

Can anyone tell me what the option actually does? I did a quick search in the syvecs manual but couldnt find the option. I should really have been in sMon!........

I got an answer that this is some kind of sanity check for the Cal answered elsewhere.

I can calm down again.