CalSelct Display on Tacho (for old pulsed tacho cars)
-
- Posts: 18
- Joined: Thu Jan 10, 2019 8:14 pm
CalSelct Display on Tacho (for old pulsed tacho cars)
Like all the modern kits do with CAN bus, it would be awesome if all the old cars out there with a pulsed tacho could get calSelect displayed temporarily on the tach like the new kits.
-
- Posts: 1347
- Joined: Sun Dec 07, 2008 2:04 pm
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
Is the number on a rotary switch too hard to see ?
And how would you propose that worked on your tacho whilst driving ?
And how would you propose that worked on your tacho whilst driving ?
-
- Posts: 18
- Joined: Thu Jan 10, 2019 8:14 pm
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
I don't have a rotary switch. I use factory toggle buttons in a stalk, repurposed for map selection.
The tach would temporarily display the selected map as the maps are being changed then after a short pause, return to displaying engine speed, just like a Syvecs CAN based system...
The tach would temporarily display the selected map as the maps are being changed then after a short pause, return to displaying engine speed, just like a Syvecs CAN based system...
-
- Posts: 1347
- Joined: Sun Dec 07, 2008 2:04 pm
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
Ahh right, you said this was for an old car.amdisthebest wrote: ↑Sat Oct 07, 2023 5:30 am I don't have a rotary switch. I use factory toggle buttons in a stalk, repurposed for map selection.
The tach would temporarily display the selected map as the maps are being changed then after a short pause, return to displaying engine speed, just like a Syvecs CAN based system...
Conventional rotary switch is a lot more practical. Especially if you ever wish to make changes on the move and be sure where you change to.
-
- Posts: 18
- Joined: Thu Jan 10, 2019 8:14 pm
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
There's lots of other ways I could do it, but I prefer my OEM integration and would love a display.
Re: CalSelct Display on Tacho (for old pulsed tacho cars)
This is now done guys, will release with 1.752 firmware today
-
- Posts: 18
- Joined: Thu Jan 10, 2019 8:14 pm