Latest 50hz GPS Firmware

50Hz GPS and IMU Module
Post Reply
Ryan.g
Syvecs Staff - Caretaker
Posts: 355
Joined: Fri May 30, 2008 3:05 pm

Latest 50hz GPS Firmware

Post by Ryan.g »

This thread is for tracking the firmware builds for the Syvecs 50Hz Gps Modules. When a new release is available it will be added to the end of this thread.

A manual on how to flash the latest firmware is here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

Any further Questions please E-mail support@syvecs.co.uk or speak to your nearest dealer
Ryan.g
Syvecs Staff - Caretaker
Posts: 355
Joined: Fri May 30, 2008 3:05 pm

Re: Latest 50hz GPS Firmware

Post by Ryan.g »

Firmware 1.2 of the 50Hz GPS Module is attached below. This firmware will be loaded onto new sales from the 10/3/21 if you purchased before then we recommend updating.

Please use the Syvecs Updater program to load the ENC file. Guide here http://www.syvecs.com/downloads/Syvecs_Updater.pdf

ENSURE the GPS is sealed again if using in harsh environments with a silicon based sealant

The 1.2 Firmware fixes the following issues:

* Added Support for Bosch MM5 (see manual for Can Info - http://www.syvecs.com/downloads/Syvecs_ ... Module.pdf)
* Added Support for Motec M1 Series (see manual for Can Info - http://www.syvecs.com/downloads/Syvecs_ ... Module.pdf)
* Fixed Uart Boot Issue
* Faster Wakeup of Device on Canbus
Attachments
SyvecsGPS_v1_2.zip
(16.18 KiB) Downloaded 89 times
Post Reply