Custom map for DCCD control?

[secure]

Hi,

Just updated the new firmware and it looks amazing! I watched the help video but I'm a bit lost between AUX PWM FAN FUEL IGN output things..




On my configuration FUEL5 was used for DCCD control. Can I make a 3D custom map for DCCD by using my YAW sensor, TPS versus DPCDuty? I'm confused between the outputs..

Thanks

[Ryan.g]

Hi,

The Brake by wire and Fan assignments can all be turned into Custom maps.

So you would first click V, C to get into the customising window on the latest software and firmware.

Here you would want to use a Fan output which is setup for PWM and has a (PWM) assigned... Like Fan6

Then on the Output Use, Change the names to Say DCCDControl

After select the Parameters for the Axis

So Yaw on X and TPS on Y

Then press esc and the proceed option

After click V, C again and go down to Output Functions - Fan6

Here you can enter the PWM Freq and adjust the breakpoints for the Map

When finished move the Fuel5 assignment to Fan6 and off you go

[secure]

When finished move the Fuel5 assignment to Fan6 and off you go

I did all of them and left my brain at that finish. I couldn't think to move fuel5 to fan6.
All my confusion gone now =) Thanks Ryan!