Slave Comms errors

Post Reply
Steveohouston
Posts: 1
Joined: Sun Nov 29, 2020 3:43 am

Slave Comms errors

Post by Steveohouston »

Hello,

I have an X10 on a S8 with a combination temperature & pressure sensor monitoring intercooler inlet temp & pressure. I continually get a Slave Comms error for both sensors under ECU errors even though both sensors are reading correct.

Any suggestions on how to stop these?

Also, is there a way to do a resistive output for a resistor type oil pressure gauge? The stock gauge is a resistive gauge and the stock pressure sender did not read the pressure range needed. I have a 10 bar, 5v sensor straight to the S8 but would like to do an output to the stock gauge to eliminate a gauge warning error on the stock dash. Would prefer to not run 2 pressure sensors.

Thank you!
Post Reply