Toucan Firmware Release V1.30
Posted: Wed Dec 04, 2013 11:01 pm
Toucan firmware V1.30 and corresponding new User Guides are available for download now from the JTi website
V1.30 is a significant release with a host of new functionality as follows:
V1.30 is a significant release with a host of new functionality as follows:
- Turn display off to avoid distractions by press-and-hold the manual display dim button (all)
- Adds AFR text to lambda gauge
- Return to previously viewed large gauge by press-and-hold any gauge on the main screen (all)
- Flex Fuel gauge (with text in % as well as gauge) (Syvecs)
- 12,000 rpm gauge as alternative choice to 10,000 rpm gauge (all)
- PIN protect first CAL added – can selected alone or along with last CAL (e.g. Valet mode aas well as immobiliser mode) (all)
- Increased sleep timeout when switched live removed – display more likely to remain alive during cranking if wired so that switched live feed is not active during cranking. (all)
- Injector duty display on Injector Duty large alarm gauge (all)
- Ignition Knock Retard per cylinder on large knock alarm gauge (Syvecs, AlcaTek)
- New “list” mode that shows all available parameters as text rather than as a gauge
- Added wastegate duty and ignition advance to the list display (all).
- Manual editing of Syvecs CAN frame/slot assignments, especially for vehicles using a CAN bridge or other non-standard CAN definitions. Can be used to disable parameters if not needed (e.g. knock retard on cylinders not present). (Syvecs)
- Display of current traction control (TC) CAL on the main screen, and ability to name each TC CAL as per main CALs (Syvecs).
- CANbus control of CAL selection (frees up an input pin) (Syvecs).
- CAL override to jump directly to a CAL pre-defined in SCal, when using CANbus control of CAL. Selectable on any or all of the 4 pages through the gauge setup screens (Syvecs).
- ALS on/off from the screen, when using CANbus control (Syvecs - already supported on AlcaTek and MoTeC).
- CAL output voltage wire will follow TC selection menu rather than CAL selection menu when CANbus control of CAL is enabled (Syvecs).
- Currently connected ECU shown on “More” pages –also shows if ECU is not connected to assist fault finding (all)
- 500kbit/s CANbus mode (MBE)
- Some help pages added
- Labels on main screen for CAL, ALS and TC now picked from first 5 characters of the entered text rather than hard-coded (all).
- MoTeC Support. Allows Launch RPM adjustment, LC on/off and ALS map selection and on/off).
- MBE Support. Allows Launch sector selection. Choice of OBD-II or Superseal connection leads.