EGT Calibration ?

For sharing Syvecs Engine Control Calibrations.
Post Reply
stevieturbo
Posts: 1023
Joined: Sun Dec 07, 2008 2:04 pm

EGT Calibration ?

Post by stevieturbo »

Should all K type probes be the same ?

I bought one of these to use, https://shop.vems.hu/catalog/sensor-type-p-53.html

But the only EGT in the Sensor DB lists a Texense 1250degC unit

This seems quite off with this probe, readings also seem erratic. Ambient sits at around 70degC

When running temperatures are sky high, over and above anything sensible
pat
Syvecs Staff - Cleaner
Posts: 356
Joined: Fri May 23, 2008 9:23 am
Location: Out there... somewhere
Contact:

Re: EGT Calibration ?

Post by pat »

EGT linearisations are normally for non standard responses, a flatline 0 everywhere in the linearisation table is used to signify a standard sensor.
Post Reply