Syvecs Forums

For now i contacted devil developments about the CAN bridge and see what they said about this problem.. Or maybe i can change something.

I wait my reply from devil and see what is next.

here is my calibration file, the log file have to make it tomorrow.


You can see that in the io configuration the wheel speed sensor is not configurated. that is because the CANBUS bridge.

That doenst make sense to all.. I make one big change on it by minus 25 and nothing happends

Don't read it good

Thankyou i will try that this week and see what happend.


And if i do a big change on the number of teeth per reading?

Yes sorry it is not static.. It goes up when i drive harder and decrease when i lower my speed...

No devil didn't install my syvecs because i live in holland. But he have made the cable loom with the canbus box ans DBW box.

Than i have to try that what you say put some extra teeth on it.

That was said to me from devil developments.. The syvecs reads the signals through the canbus..



When i drove i see the speed sensor in syvecs reads 0.5kmu when i drove 20kmu on the dash.. So im getting a speed signal in my syvecs but not the speed that i drive on the dash..

Mm yes i have to figure it out where the syvecs gets the speed. It is reading from the canbus and in the syvecs he reads what i say in my post like 0.5 in syvecs and around 20kmu on my cluster so that is strange.

hello. i have the syvecs installed in my focus rs mk2 now, but now i want the gear position working on it and the speed reading. The problem is that the syvecs reads only the first gear and not the others gears and the speed sensor read when i drive like 20kph the syvecs reads 0.4 i think... Does an...