Syvecs Forums

Just to conclude this for my application. I spent some time today going through and checking the triggers - with a scope at high rpm the falling edge had somewhat of a knee in it after 1.5v with a noticeable slower response that the rising edge at the same RPMs. This is where my issue lay, at idle a...

Hi all,

I went to copy a lambda sensor scaling yesterday and realised that I can't - when you do N>B>L I get the error:

"There are no appropriate sensors"

Yet in the Program folder there are...
See attached screen shot.

I get the same with LifeCal... any ideas?

I'm 100% with you, but this car has to retain the setup it has for various reasons that are beyond this conversation OR professional advice. Trust me, I'd rather run it on a proper trigger wheel with D585s etc. It's not timing light related - it's reading right. I'm pretty sure it's due to the decre...

Hi all, I've got a little question in reference to spark latency. Background: American V8 with MSD distributor which has hall effect outputs for crankshaft position [1 per cylinder, 4 per crankshaft revolution] and a phase tooth. Running sequential fuel on an S6 with all ignition events sent to one ...