Syvecs Forums

But what if you used the sqs gearknob to instigate the shift giving you a rising voltage when operated both directions and the cable sensor was purely used as a gear location sensor to tell the ecu when it was in gear to stop the cut once the gear was reached? (both needed for closed loop) The thing...

I ordered my gear knob through SQS and it arived the NEXT day from Prague! How awesome was that. So what Atomic is saying if i get this right is that the sqs microswitch knob can be used to start a cut as it has the same output in both gearstick directions, but if you set up and calibrate the cable ...

Thanks again for answering my questions stevie, Sqs have just replied, which gearknob would I require the basic one which is 2 switches both giving the same signal. The one way which is 1 switch only one way, or the 2 way which is 2 switches one switch for up gears output one down gears output. I'm ...

Many thanks again Steve for info. Does anyone over here do the microswitch gearknob? I've tried to contact sqs but with no luck. Could i use a geartronics gearknob? Or does the voltages make a difference? 0.5v-4.5v biased in the middle at 2.5v. Or does the fact it differs in voltages mean I couldn't...

Thanks for your swift reply stevie, with an open loop setup using the sqs gear knob is there a way to make the across gate shift cut (2-3) longer than the 1-2 and 3-4 or would it have to be an average time for all shifts? So the sqs gear knob supply's the same voltage in either direction making the ...

Does anyone have anymore info on this thread? Has it been done before? Is anyone running gear cut with H Pattern Dog box? I'm curious as have just fitted a Dogbox myself and would really like to be able to flat shift. An help great fully recieved.