Syvecs Forums

Charles, did you get and answer on this?

I also have the RS232 pins already taken up by a Comms connector (in my case an RJ45).

Ideally a cable from this to the bluetooth would save a lot of trouble !

UPDATE:

I went through all the relevant cruise control and cal switch calibrations. I now have the Cruise stalk working as the up/down cal switch, and cal override is enabled by putting the cruise control switch into the off position.

Is there any way, apart from with Scal connected to the ECU, to ...

OK, I have checked and the cruise control is not working in any instance. Not in it's normal operation and also not as a cal switch.

The cruise control stalk also must be forward in the on position to enable the switch to go up/down, as in the back/off position it is unable to move.

I have checked ...

Thanks Ryan,

Confirmed Cal Override is Disabled.

I will check the cruise stalk to ensure it is not in the ON position and reply. Hopefully it is that simple .

Thanks Tim,

You are likely right, this is most probably a Can bus function.

I've had a quick look in SCAL and notice that the ECU is set for a custom canbus datastream and also to receive canbus info from the ABS:

Datastreams / Bosch ABS M4-kit / Receive Bosch ABS M4-Kit CAN frames / YES

Also ...

Hi,

I am running the S12 R8 PnP with a basic calibration that I believe came from Ryan's car.

The cruise control is not working as a cal switch.

I have the following I/O Configuration and Pin Assignments:

Cal down switch : NOT CONNECTED
Cal up switch : NOT CONNECTED
Calibration override switch ...

Thanks for the reply Wez, it did help me figure out the problem.

I did not have the firmware update file correctly located in my workspace, so could not find it when using the Config / change software version facility in SCfg.

All sorted and working now. Thanks again.

Hi,

I am trying to set (Load) a new Scfg calibration onto my ECU.

The file I am using is from my tuner, and is Scfg Software Version 1.518.1.

When trying to Set the file onto my ECU using Scfg, I get and error that requests I convert the file to 1.538

I am using, and only have ever loaded, the ...