Syvecs Forums

Hi guys, I just watched the youtube on gauges, and have lots of gauges setup. But I can't remember or find how to set up preferred gauges to be accessible by clicking "g" then a number to select a quick access gauge. The video doesn't mention it, but I can access my ALS gauges by clicking "g" "1 ...

Hi guys, I read the descriptions but it doesn't describe how the decay works, or I am not fully understanding.

-Does positive decay related to increasing throttle position and negative relate to decreasing?
-Does a larger positive decay mean that TFC is shortened
-Does a larger negative decay mean ...

Hi guys, I understand "wg3maperrpct1" essentially outputs the invert of what its actually doing, so I was wondering if anyone could point me in the direction of how to build a math channel to flip the sign from negative to positive or visa versa. I was trying to figure out out how to get the channel ...

S7+ ECU, nothing in the Syvecs range has near enough for a several hour long endurance race.

Is there a way to stream to a laptop via full logging or would it just be via the gauges?

Thanks!

Do you guys know of a way we can increase logging capacity for endurance racing?

Thank you!

Hi there,

Maybe I am not understanding the terminology but with regard to these two items:

-Does increasing the failure rate make the time to failure increment more quickly or less quickly?
-does increasing the recover rate allow the sensor to be considered "recovered" more quickly or less quickly ...

@littlefella thank you for looking.

I've attached a screenshot with the cursor on limp mode; error flag is 1024 (lambda 2 in my case) and limp mode shows "sensor warning level".

I'm not seeing the decode like yours, maybe I'm missing where to look. Thanks again for the help.

I looked in the manual and at the videos, and could not find an explanation on how to convert the error flag number that is produced by the log to the actual error specified by the "error flag items bit assignments".

I do understand how to set the severity by group, but not how to determine what ...

Will do, car is remote so not always able to go live.

My understanding from most logging programs is start speed 2500 will start it above 2500, and stop it below 2000, after its below 2000 for the delay period.

Hi guys, I have datalogging enabled on all cal switches, and it starts at 2500RPM as expected but does not stop below 2000RPM (and when off throttle)

Can you look and see if you can find my error?

Log continually: no
Log when syncstate is not stop: no
datalogging start speed: 2500
datalogging stop ...