Syvecs Forums

I am running 6 K-type thermocouples on a V6 engine into a CAN-Bus transceiver. I am receiving these as user definable sensors on the F88. Is it possible to build an average math channel from the the individual cylinder on each side to use it as egt1/egt2 channel for lambda-target correction and ALS-...

Do I understand correctly that you are injecting 4.113cm³/min fuel and 2.388cm³/min water?
That would be 58% WM (or even more if you calculate it in fuel mass). I Ihought that usually about 20% is the target?

Just trying to learn something...

I can add some infos on the Aquamist sensor. I just tested one. It works with a Syvecs ECU. Pinout: 1 red 5V Power supply 2 yellow Turbine Flow Sensor signal output 1mA max@5V 3 blue Feedback Signal (return ground) 4 black gnd These are from a Aquamist paper, I can not confirm these: 0ml/min 0Hz 250...

For a more exact metering I want to use two Injectors (Bosch 0 280 158 827 NGI2) on a V6 engine for WMI injection. My thought was to wire these injectors as secondary fuel injectors (so they will be in sync with the engine) and fire WMI1 on cyl 123 and WMI2 on cyl 456. When I configure this in the p...

I am running a F88 on a Renault 3L twin turbo engine. I am in the process of upgraqding the turbos and adding some more sensors.
I also decided to use two 60mm DBW throttle bodies. These are the Bosch units used on all current McLaren engines.
Can anyone help with a calibration?