Syvecs Forums

sorted now, the sensor information is on the downloads page of jti, thats can then be loaded in through the sensor from the linearisation file under sensor db

hi i got the sensor pack from jti, act,oil temp, oil/fuel pressure, the temerature give the file as a temperature to resistance , i have seen the equasion on here how to do it but i dont see all the variables, i just wonderd if anyone had a cal file i can be sent so i can copy the data across which ...

as i said it was what i over heard so dont shoot the muppet! :shock: but the hot side had colapsed - the bridge between the two scrolls leading to the hotside wheel, blocking half of the route in to the impellor but not only that its had a large crack venting gasses out so pretty knackerd, yes the e...

im sure this has been asked before, is there anyway to use a syves s6 to run a system like the 'zerolag' system, i dont see a reason not to (i am more than likly missing something!) but it can already do antilag by jacking the throttle is there a way it could just controll the solonoid on the compre...

i had my car mapped the a few weeks ago, and did 380hp on a poorly turbo, i changed it expecting to see the same power and better spool, but spools there but not the power, its noting machinical, the boost is there right to 7.7krpm, what could be the issue, but it was mapped on my old syvecs which h...

got it sorted now, it was a due to the gear input i had put in.... it was conflicting with gear form wheel speed, thanks pat & Paul at zen (pavlo)

hi, i have the same sensor in another car on the same type of input (working one is in AN04, this one is in AN03) would you recomend pullin g out the oins and see if it still starts working - as the pumps dont prime at the moment! :S

I were just trying to connect a gear position sensor to pin 37 , for some reason iI couldn't get the syvecs to read the voltage change, then under cOnnection it says connected but not in sync?! Also now I have noticed it says it's booted to boot code 1.2. Have I murdered it?! :o note battery were a ...

hi, im pretty new to all this..... but my real bug bear with the syvecs (i have an s6) is the 720sync lark, couldnt it be set to start at 360, and the data then selected once the engine had fired and put into effect onc its running? as my starter and small race battery doesn't like it (fine on the s...

i have just got a s6 for my Evo, and i am wanting to set up flast shift (it has a maktrak seq gbox, and geartronics microswitch activation) basically how do i do it!, is there a manual? (step by step would be awesome :lol: !!!) as i need to find where i need to wire it into, is it swiched earth?! ho...