Syvecs Forums

Just FYI, "Jack", is a spambot. Another one...yet another one. I've reported it a few times, but it's still there. As I have the JTi section here - and perhaps accidentally - I ended up with moderator privileges and for the last few years have been deleting the spam posts. I have not been...

stevieturbo wrote: ↑Fri Nov 17, 2023 10:17 am For what purpose exactly ? I'd doubt the ECU master would be compatible ?

S6 cannot receive additional inputs via CAN. Is this S6?

If S7, with 2x CANbus, you can receive data via CAN and the ECU master expander can almost certainly be configured to work.

It's a limitation of the slave protocol rather than X10. Not enough bandwidth on the link to cope with much extra data.

:!: Warning - my information might be a few years out of date but I am 99.9% sure it still applies :!: The "slave" protocol runs in a non-standard fashion, at a non-standard data rate. It both transmits and receives "slave" data frames over the CAN link and is (pretty much) exclu...

Does it even support OBDII data?

stevieturbo wrote: ↑Wed Mar 29, 2023 6:35 pm I don't have one here to test, so can't say.

But it would be unusual, yes.

I doi...but on holiday...I'll make a note to investigate this when i get back

I have heard quite a few people report S7 outputs causing relays to turn on when the ECU is off. Whilst Stevie is right - it is best not to have a relay powered by a permanent live - I personally do not think it right that an ECU output can sink enough current to turn on a relay when the output is o...

As a general reply, if you assign X-CAN to a device/sensor then the scaling of the received data should match the format that would be used in the transmit stream. In the case of a CAL switch I believe that means it will expect 1, 2, 3 etc, rather than the mV equivalent/replication of an electrical ...

According to the manual it's to: "Playback recorded calibration adjustments (engine dyno use)"

If you only want ALS active while the switch is pushed, you can use a momentary switch without issue. The software doesn't know the mechanical construction of the switch. If you want a press/release of the momentary switch to turn it on, and a second press/release to turn it off then, as has been sa...