Syvecs Forums

Problem seems to be too small distance between vr sensor and flywheel. It should be orginal peugeot distance but when I installed 0.8mm shim it start to work !

Problem seems to be (at this point of testing) vr sensor signal which kill the ecu pin after another on high rpm (now I have lost 3 ecu pins on testing this problem so something must be done now :roll: ). Always close to rev limiter or right away on next gear. Wiring seems to be right. Now the focus...

Hi!

Ok I write email. Still not working and I try to figure out what is the problem.

-Mikko-

Hello! I was driving on the road and suddenly engine stopped. Crank sensor did not give signal anymore on starting after that. Attachment is synch log at the end you will see final situation before engine stopped. Also there is cal-file. I have tested with another new crank sensor but no signal. I t...

Now I am playing with boost BUT I think I need simple advice for everything... 1. Solenoid connections Upper: To wastegate upper port (Phase) how do I connect solenoid ? Does it get always full boostpressure until solenoid start bleed out and starts to control boost level or does it get boost pressu...

Thanks again !

Launch Control: I have left from my past ecu (DTA) a launch control switch. That is installed on gearstick and launch control goes ON when you keep pushin the button and goes OFF after you release it. Can I connect it to S6 with same kind of launch control function (control stay ON so far as you kee...

Thanks!

I start testing those (not yet because we have still 60 cm snow...). My goal is to have 2-2.5 bar max boost as stable as possible but still able to get low boost for the first gears.

-Mikko-

Hi!

My plan is to control external wastegate with 2 separate solenoids (one for the upper and one for the lower).

How is it done with Syvecs ?

Some simple advice would be nice. This is my first time for doing it that way, normally I had one solenoid only for the upper side.

-Mikko-

Now it works, Cam Raw data told me correct angles so it is now fully sequential.