Syvecs Forums

Please excuse this question if it seems obvious to most here - but I cannot find within SCal a few things I was expecting(?) to see relating to injectors - namely specifications for flowrate (cc/min) and impedance (though I understand the S6 for example only support high impedance injectors).

Can anyone enlighten me?

-Ed.

dr_jones wrote:Please excuse this question if it seems obvious to most here - but I cannot find within SCal a few things I was expecting(?) to see relating to injectors - namely specifications for flowrate (cc/min) and impedance (though I understand the S6 for example only support high impedance injectors).

Can anyone enlighten me?

-Ed.

Flow rate does not matter, unless you're wanting some sort of fuel used measurement, where you can input a value under Fuel Consumption section. Not sure whether it's a trial and error thing though

And yes it only allows high impedance.

Ah - thanks!