Syvecs Forums

Hi is there a toucan set up post
Fitted the toucan to s6 but says not connected to ecu.

Thanks

User Guides on our website:

https://jti.uk.com/user-guides/

Also be aware of Toucan firmware version issues relating to the S6 (https://jti.uk.com/software-and-firmware/) if you are using RS232 - you need to use firmware older than V1.90

Usually, if you follow the User Guide to set up the datastream, it will "just work".

Great thank you

On can 1m and still not reading ecu.
Grey wire is only wire not connected as im using cal switch
Canbus termination is off ?

Basky wrote: ↑Sat Aug 21, 2021 7:02 pm Canbus termination is off ?

Obviously worth a try - technically it should be ON but if S6 and Toucan are the only devices on the bus it usually works.

Without more details it's rather difficult to advise - for example: new or second hand Toucan; has it ever worked; attach your CAL and I can check that it really is set up OK; second hand S6...possibly one of the 500 that didn't have CANbus, so have you tried RS232; what Toucan firmware version. And things like that.

Yes ive tried on and off with the canbus.
The toucan is new last week.i work away in the week so cant call help line as i cant be with the car.ive tried can1 and r232 and same results .
Not sure how post pics of the screens.
Have got whatsapp if possible to send through ?
Thanks

V1.84a

That version (although not what new units ship with) is known to work OK.

Various possibilities:

- faulty/damaged cable
- mismatch between Toucan CAN datarate and S6 settings
- S6 datastream not set right (attach your cal file here or send it to us direct)
- Toucan cable plugged into Ethernet connector instead of comms connector
- if S6 PnP have seen problems with comms connector not soldered in very well or shorting on ecu case.
- Being S6 it is obviously an old unit; could be faulty perhaps?

So if the comms socket if damaged how would i find out ?
The cable is brand new so that is under warranty.
Failing all this i,ll return the toucan to jt.
Can the comms cable be hard wired in ?

All plugs in correct place.
Did a constituency test on ecu plug from toucan and all ok so cant be the loom.
Maybe the comms plug like you say tim.can this be repaired or hard wired ?

Thanks