2020-06-11 wont install ?

Post Reply
stevieturbo
Posts: 1321
Joined: Sun Dec 07, 2008 2:04 pm

2020-06-11 wont install ?

Post by stevieturbo »

I get this error when trying to install ?
install error.jpg
install error.jpg (38.23 KiB) Viewed 10167 times
stevieturbo
Posts: 1321
Joined: Sun Dec 07, 2008 2:04 pm

Re: 2020-06-11 wont install ?

Post by stevieturbo »

2nd attempt after partial uninstall yielded this
install error 2.jpg

3rd attempt seemed to go ok...although havent tried to connect yet
stevieturbo
Posts: 1321
Joined: Sun Dec 07, 2008 2:04 pm

Re: 2020-06-11 wont install ?

Post by stevieturbo »

image didnt appear ?
install error 2.jpg
install error 2.jpg (89.2 KiB) Viewed 10163 times
Slowie
Posts: 123
Joined: Thu Jan 17, 2013 7:30 am

Re: 2020-06-11 wont install ?

Post by Slowie »

Mine updated without issues on two different computers, for what it's worth.
stevieturbo
Posts: 1321
Joined: Sun Dec 07, 2008 2:04 pm

Re: 2020-06-11 wont install ?

Post by stevieturbo »

My desktop PC went ok...laptop had the issues.
jezzpalmer
Posts: 66
Joined: Thu Mar 05, 2009 10:43 pm
Location: Swansea

Re: 2020-06-11 wont install ?

Post by jezzpalmer »

A bit late to the party with this but I had the same issue; seemed that I had an existing instance of Scal running, and the network server.
Once they were closed all was well.
stevieturbo
Posts: 1321
Joined: Sun Dec 07, 2008 2:04 pm

Re: 2020-06-11 wont install ?

Post by stevieturbo »

Worth noting that on my laptop....it would not communicate with an ecu after I installed, but one install attempt did say the comms drivers had failed.

So I re-installed an older version, it communicated, and then I tried again to install the new version, and then it communicated.

No idea what's going on, as never had issues like that before with any other install.
stevieturbo
Posts: 1321
Joined: Sun Dec 07, 2008 2:04 pm

Re: 2020-06-11 wont install ?

Post by stevieturbo »

Bumping this again.

Strangely in order to use this version, every time I boot up the laptop I need to install the software again otherwise it will not find or connect to the ecu
Post Reply