This
Link is for version 1.31.1 of the S6 firmware.
This is a features / tweaks release and adds the following :
Full Flex Fuel support using GM Flex Fuel sensors
* fuel composition (flex fuel) sensor input (frequency input)
* f(fuelComp) transition curve for base fuel
* in flex mode blend run-mode base fuel maps
* f(fuelComp) transition curve for base ignition; monitoring item flxTrIgnBase
* in flex mode blend run-mode base ignition maps
* in flex mode blend run-mode base secondary ignition maps
* f(fuelComp) transition curve for preliminary injection; monitoring item flxTrFuelPrelim
* in flex mode blend crank-mode preliminary fuel maps
* f(fuelComp) transition curve for start fuelling; monitoring item flxTrFuelCrank
* in flex mode blend crank-mode base fuel maps
* f(fuelComp) transition curve for start ignition; monitoring item flxTrIgnCrank
* in flex mode blend crank-mode base ignition maps
* in flex mode blend crank-mode base secondary ignition maps
* four wastegate map target limit f(rpm) curves, selectable on cal switch
* f(fuelComp) transition curve for map target max curve; monitoring item flxTrWgMapTarg
* in flex mode blend wastegate map target limit maps
Adjustable Map Limits based on Cal position - Ideal for adding extra safety when a mixture of different fuels are used on one calibration.
* two map limiter base f(rpm) curves, selectable on cal switch
Rover K Series Trigger Support
Update to Launch Strategy to add the following
* launch limiter : ability to disable knock control during launch limiter
* launch limiter : launchAddCalSw becomes launchRpmAddCalSw
* launch limiter : launchMapCalSw becomes launchMapAddCalSw
* launch limiter : auto start clutch state (armed minus clutch)
* launch limiter : auto start option to crank in armed state with timeout
* launch limiter : auto start armed indication output
* launch limiter : auto start armed indication output also on in clutch state if cranking enabled in armed state
* launch limiter : engineEnable=EE_AUTOSTART in auto start armed and cranking; prevents engine start
* launch limiter : if ignition retard timeout is zero, never time out to fuel cut safeties (only use on high egt)
* launch limiter : ignition retard disable by egt is only while egt high (can recover if egt falls)
* launch limiter : stays active for a hold time after switch release or exit speed threshold
* launch limiter : launchHoldTimer monitoring item - time since switch release or exit speed
* launch limiter : add manifold pressure target ramp similar to engine speed target ramp
* launch limiter : change calsw map target to calsw map target adder (as for engine speed)
* launch limiter : rpm and map ramps switchable f(vehspd) or f(launchHoldTimer)
* launch limiter : exit mode after engine control disengaged (launchExitState/launchExitTimer)
* launch limiter / wgc : wgcMapLimitAddLaunch f(launchExitTimer)
* launch limiter / n2o : n2oMltLaunch f(launchExitTimer)
Enjoy