Page 3 of 10
Re: More water / meth injection
Posted: Wed Jun 03, 2020 11:27 am
by RICE RACING
Hyundai RM-19 prototype with some 'familiar parts'
- LR WI set up.jpg (647.8 KiB) Viewed 209558 times
Re: More water / meth injection
Posted: Wed Jun 03, 2020 6:15 pm
by stevieturbo
It's certainly overdue !
The dedicated water injection feature is rather lacking.
Re: More water / meth injection
Posted: Wed Jun 03, 2020 8:34 pm
by Gpro
I too look forward to seeing more advance water injection features in Syvecs!
Re: More water / meth injection
Posted: Fri Jun 05, 2020 5:56 pm
by Trickster
Unless you are on S6
Re: More water / meth injection
Posted: Fri Jun 05, 2020 7:13 pm
by stevieturbo
Trickster wrote: ↑Fri Jun 05, 2020 5:56 pm
Unless you are on S6
You can still do custom tables and do water injection well, and safely with an S6. If you have one input and a spare output...job done.
Re: More water / meth injection
Posted: Sat Jun 06, 2020 11:37 am
by Trickster
Yeh I know mate, I was just being funny because there are no more firmware updates haha
Re: More water / meth injection
Posted: Mon Aug 10, 2020 1:51 am
by RICE RACING
Now doing full integration with Dash/ECU, running complete strategies to measure flow/s, status, and per bank or rotor control.
Basics are:
*low flow
*high flow
*differential flow
*Solenoid fault
*Pump fault
Other items to follow....
Re: More water / meth injection
Posted: Mon Aug 10, 2020 8:09 am
by RICE RACING
Simulation testing the control logic, all works
Maths used is allot more than posted above but hope it helps people interested in doing this.
Final Solution counters all Leak Block or Differential detection limits (Bank 1 Bank 2) or in this case per rotor
- dirrerential flow status error.jpg (930.09 KiB) Viewed 208808 times
- perfect WI test.jpg (919.34 KiB) Viewed 208808 times
Re: More water / meth injection
Posted: Mon Aug 10, 2020 5:45 pm
by stevieturbo
So have they finally allowed frequency inputs on the ecu, or did you have to do a workaround ?
Re: More water / meth injection
Posted: Mon Aug 10, 2020 11:15 pm
by RICE RACING
stevieturbo wrote: ↑Mon Aug 10, 2020 5:45 pm
So have they finally allowed frequency inputs on the ecu, or did you have to do a workaround ?
To do the control items I showed an example of above you need the maths ability of a LR/Syvecs D4/D5/D8 dash unit.
For the frequency input currently need the use of both ECU and dash and wheel speed B channels used on ECU. It is down on the list to allow generic frequency input ability though.
Other power circuit related stuff I am using the PDUx3 states and the D4 dash to give status of the high speed valves and WI pump.
