Manual Cam Checklist help

Post Reply
NenadNR
Posts: 8
Joined: Mon Oct 29, 2018 8:30 pm

Manual Cam Checklist help

Post by NenadNR »

Hi,

I need help with Manual Cam Checklist configuration. I read and tried all I funded on this forum but no luck. Crank trigger is 60-2 and it is working alright. Cam trigger can be seen on picture. There is no VVT. Both crank and cam sensors are hall.

Image

Engine is with direct injection so 720 sync is needed on cranking before start but I can not get it.

Thanks
stevieturbo
Posts: 1311
Joined: Sun Dec 07, 2008 2:04 pm

Re: Manual Cam Checklist help

Post by stevieturbo »

Can you do a scope trace with a spark plug in cylinder 1 only ?

It's easier for me to visualise what to do that way, and should be able to see where cyl1 is on the trace.
stevieturbo
Posts: 1311
Joined: Sun Dec 07, 2008 2:04 pm

Re: Manual Cam Checklist help

Post by stevieturbo »

ok...try this...and i'm taking from your arrow that the small tooth on top will be the first tooth seen during normal rotation.

checklist entries = 3

Angles, 90, 180 and 350 ( I'm basing this on a rising edge trigger so if you are not using this, it will change )

Counts phase 1, 0-1-1
Counts Phase 2, 1-0-1
NenadNR
Posts: 8
Joined: Mon Oct 29, 2018 8:30 pm

Re: Manual Cam Checklist help

Post by NenadNR »

Thank you.
I will try later today.
NenadNR
Posts: 8
Joined: Mon Oct 29, 2018 8:30 pm

Re: Manual Cam Checklist help

Post by NenadNR »

It works. Thank you very much.
stevieturbo
Posts: 1311
Joined: Sun Dec 07, 2008 2:04 pm

Re: Manual Cam Checklist help

Post by stevieturbo »

good stuff.
Post Reply