Syvecs Forums

Hi Are you doing a fresh install, or upgrading an existing software installation? With Windows 10, I find I have to always restart the PC first before upgrading/installing, else the installer baulks when it gets to the Ethernet drivers. Edited to add that after the restart, don't run any other softw...

Please also include the starting datalog, with warmed up wideband sensor (takes around 30s to warm up). That will help to diagnose starting fuel.

Forgot to ask, does it start like that with cold and hot engine, and also with cold and warm ambient conditions?

That definitely is not normal. It seems to be purely a mapping issue, just looking at the video. You are already running the Subaru G11 crank sensor setup, which has faster starting than the G10 type. Has the car been mapped? The starting settings seem very close to the Subaru base map values, and m...

As per TimH, if you have the Syvecs supplied DBW driver, setup the output to Low Side.

It is an error in the video, or the info changed since the vid was made some time ago.

You could also try Ryan's advice here, of teeing into the + wire from a rear wheel speed sensor at the ABS ECU, and setting the input to 5V.

Two thumbs up.

Yes, you have to be careful of that. I guess the pinout has to be different because of the different operating principles (no coil).

I use one of those to control my water injection pump (with Schottky flyback diode across the motor). Nothing to report, works fine. Silent, doesn't get hot even when I had the pump running at 90% duty cycle for 20 minutes, recycling into the reservoir, to test the reliability. I run it from 10-90%....

In SCal, Gauge -> add New Math and manage existing Math. Those items weren't there in the previous software version (2016-12-02)

Just want to thank you guys for the math function which to SCal in the latest software suite. I only found it by accident!

In light of this, could you perhaps also issue a brief list of changes to the software when a new version is released?

Thanks