Search found 43 matches

by Steve
Mon Aug 26, 2013 2:58 pm
Forum: Syvecs Bluetooth Module
Topic: Syvecs Bluetooth Module
Replies: 11
Views: 35242

Re: Syvecs Bluetooth Module

Now what we need is bluetooth/CAN or bluetooth/serial controller in one unit, so CAL's can be changed from the App on the phone. :D
by Steve
Mon Aug 26, 2013 2:55 pm
Forum: S6 GP/PnP Technical
Topic: CAN BUS Cal Switch
Replies: 16
Views: 30854

Re: CAN BUS Cal Switch

What would CAL override be used for?
by Steve
Mon Aug 26, 2013 2:26 pm
Forum: S6 GP/PnP Technical
Topic: CAN BUS Cal Switch
Replies: 16
Views: 30854

Re: CAN BUS Cal Switch

Would this also mean that options like Rolling anti-lag can be controlled by the CAN BUS or is it limited to Up/Down Cal/Trac Commands?
by Steve
Sun Aug 25, 2013 2:46 pm
Forum: S6 GP/PnP Technical
Topic: CAN BUS Cal Switch
Replies: 16
Views: 30854

Re: CAN BUS Cal Switch

Future Toucan owner here then when this is implemented :)

Hurry up :mrgreen:
by Steve
Sun Aug 25, 2013 2:15 pm
Forum: S6 GP/PnP Technical
Topic: CAN BUS Cal Switch
Replies: 16
Views: 30854

Re: CAN BUS Cal Switch

Have I read it right that the CAL's can now be controlled via CANBUS on the S6 with the new firmware?
by Steve
Sun Jul 28, 2013 10:05 pm
Forum: General Syvecs Chat
Topic: Resistance to voltage conversion
Replies: 5
Views: 12861

Re: Resistance to voltage conversion

I have set most of it now I think, I have set them as close to the current breakpoints using the excel sheet above. With how they were set previously the ECU was seeing ACT of 60 when it should have been 30 and EOT of 160 when it should have seen 90 odd. So they were a little out. :D The sensors wer...
by Steve
Sun Jul 28, 2013 8:11 pm
Forum: General Syvecs Chat
Topic: Resistance to voltage conversion
Replies: 5
Views: 12861

Re: Resistance to voltage conversion

Excellent, thanks for that :)

Is it possible to change the sensor breakpoints or is it a case of matching it up as best as possible to the nearest voltage point?
by Steve
Sun Jul 28, 2013 5:58 pm
Forum: General Syvecs Chat
Topic: Resistance to voltage conversion
Replies: 5
Views: 12861

Resistance to voltage conversion

I have now fitted a new air temp sensor and a new oil temp sensor. They come with the temperature vs resistance table but I need to convert this into voltage to setup the linearisations in the sensor settings.

How can this be done?

Cheers
Steve
by Steve
Sun Jul 28, 2013 5:41 pm
Forum: S6 GP/PnP Technical
Topic: CAN BUS Cal Switch
Replies: 16
Views: 30854

Re: CAN BUS Cal Switch

Any update on being able to control the cal switches by using the CANBUS?
by Steve
Thu May 23, 2013 3:22 pm
Forum: S6 GP/PnP Technical
Topic: CAN BUS Cal Switch
Replies: 16
Views: 30854

Re: CAN BUS Cal Switch

So I can just remove the CAL switches for now and just leave it set on one setting via a laptop until this update happens?