Syvecs Forums

at 100 percent it is not the cable.

You can hear in the video as the engine turns on and off.

I suspect that is the 12v voltage that is simply missing.

It is a relay on the PNP harness.

I do not know what the switch but I will the times

Hello ,
I finally managed to make a video.
here on the video the engine is cold!
I start the engine and then hold the gas.
and as you can see turns on and off.

https://streamable.com/ykwf2

So I have a pnp system from syvecs for my tfsi engine.

that it only happens in the cold state, of course curious

There is a relay on the PNP system. I think that I will change times to see if it is that the problem.

I would like to do that, but the logs do not show you because they are always stopped and because the ecu switches off. why I do not know unfortunately

hi Guys Unfortunately, I have the problem that when I start my car and go directly to start and give little gas that my ecu turns off. I can see that it turns off because a log is stored and the ECT / time table at 0 sec. begins . The problem I have only until the engine has a certain temperature (a...

Hi guys, I just wanted to ask you how to set your knock sensors and how to tune them to your engine. The video of Ryan I know meanwhile but I always have the problem that the sensor sporadically times a knock recognizes although it is nothing. I tried to play around with the Gain but it does not rea...

Thank yoou for your help guys, now it working fine=)

i only see these options the calibrate the sensor ....

Hi Guys
I have to measure on my tfsi the exhaust gas pressure. However, nothing is configured in front of "sensors".
Can I invent a "sensor" myself and enter the name? with characteristic line etc.

Best regards

TimH wrote:That's only because you haven't slid the plastic bar out 2mm or so. If I had an S8 connector to hand I'd take a photo for you, but I haven't. Sorry!

Can you maybe mark me on the picture?