Syvecs Forums

Has anybody here used one of these Race technology 8-channel expanders?

http://www.race-technology.com/gb/racin ... logmodule8

It seems like the cheapest way to expand the inputs on my S6 for extra temps, pressures, switches.

Hi

Also looking for a calibration for the AEM SR20 disc please.

I looked at the RB26 one posted earlier for ideas, but need the angles for the SR installation.

Thanks

I believe it is covered in here: https://www.youtube.com/watch?v=KbNP80P-adQ

FYI I'm testing a prototype of a simple expansion unit right now. It has: - 4 inputs (selectable as AV, AU, AB or AR types) - 1x Bosch LSU 4,2/4.9 lambda amp - 1x EGT amp - Barometric pressure sensor - H bridge output - gyro - accelerometer - USB for configuration - CANbus (of course!) This will be...

Those Siemens adaptors are what i use on the Supras, work a treat Although 99% of ABS computers will work fine if you T into the + side of the ABS signal at ABS Ecu and then set the input to only 5v on the input selection in sensor setup with the Bipolar inputs on the S6GP. (no pull-up is applied t...

3. I/O Expander Maybe add a lambda controller to this ? So S6 models could be enabled for full dual lambda control without a separate wideband controller. ( or can it do this already, havent used one yet ? ) FYI I'm testing a prototype of a simple expansion unit right now. It has: - 4 inputs (selec...

Wow! Thank you Pat. That is exactly what I was looking for.

I find it most informative.

Hi Whilst I understand the various trigger methods available in the Syvecs, I was wondering if anyone could explain some pros and cons of the various patterns, e.g. Is keyed by single cam less accurate than single gap single cam, theoretical rpm limits on each, etc. I am interested in the reasons be...

Ah, I see. I did not understand completely before. That solves my situation nicely.

Many thanks!

Thank you very much, I will keep that in mind.

Since I will then use the external DBW driver, is the I/O8 available already? I was just looking at the I/O10 because of the H-Bridge, and using the DBW driver would negate that.

The CAN I will be able to work around, thanks.