Syvecs Forums

I might have five minutes spare tonight to start going through the logs Stevie. The MBE guy was at Combe and we had a brief chat about the settings I was using, and I've some ideas now on how to improve it. I'd set the slip to 10% all the way to the L/C cut off point (40mph or 6050rpm) and of course...

I tried the new launch control parameters out on Saturday, and it was absolutely brilliant.

Can it be improved though? Have a listen.

https://youtu.be/J9xzupc-i7c

Speed sensor gap to the trigger wheel was too large on the left front wheel. It's now <2mm and works 100%. That should have resolved all the issues.

I removed the sureseal connectors, and wired the rear speed sensors (XS608B1NAL2) direct to my harness, and the sensors now work 100%. I used a spare trigger wheel on a leccy drill to test them both out, and no problems at all. The pins from the sureseal plugs were dull, so it was no wonder they wer...

That figures, hence no voltages can be seen. I've traced the fault to a pair of iffy ITT mini-Sureseal connectors that connect the rear sensors to my X10 harness. For the sake of simplicity and reliability, I shall remove the connectors and solder the sensor cables direct to my harness, which should...

Testing went ok, but I had intermittent wheel speed sensor readings, which kind of hindered the testing of TC. The two channels for the left and right rear wheel speed sensors, don't show any voltages, I just get speed when they work. They're both set to Thermistor type. The fronts do record voltage...

I want to use the same traction spin target map for all the switch positions for TC, so I just focus on getting one map setup rather than four. If I want the TC switch to reduce the Spin Target for TC by a percentage, do I use Traction Control Spin Target Multiplier, or Traction Control Gain Tuning?...

I've set the gain for TC9 to 12 to 0 to do that.

While I'm having a look at the spin target maps, I think the same calibration switch (tcSelect) also selects the Tyre Types in my CAL. Is that how the relationship with calibration switches works? The same switch 'tcSelect' can be assigned to tyre type? If that is the case, I'll set the tyre type sw...

I've installed scal and downloaded the sample file from this thread, and started comparing my map with the sample map, and even my base engine speed is nothing like the one in the sample. https://www.zetecinside.com/xr2/pictures/baseenginespeeds.png Is base engine speed like an artificial rev limite...