Syvecs Forums

Small update: I set the sensor up as it seems it should be, but still no change. I have now verified no spark or injection - both the coils, and the fuel injectors have been checked as receiving a constant power feed at key on, but no change to a pulse during cranking. The sync log shows cam and cra...

Sorry for the long delay for reply.. Checked cal and turned off anything that looked like it would be set to prevent starting, no change. I set it to without FP1 input and again no change. I checked linearisation for the fuel pressure sensor and it seems off. Can anyone advise how to set this up for...

Will check the Cal tonight. Are there any obvious areas of the Cal I should be looking at to check this? I have checked the fueling and starting areas before in case something jumped out but didn't notice anything. I'm still finding my feet with the SCal software, so if there is a definite area of t...

I determined no spark by removing the coils and grounding the spark plug, then cranking. No spark. I am a little paranoid though so I will double check this again tomorrow evening. I haven't checked for all 6 cylinders, but 2, and neither sparked, which leads me to think it must be a common point in...

Hi All, Hoping for some assistance. My single turbo build was running and idling, although with some difficulty due to a bad ECT sensor. I fitted a new sensor and new wiring and SCal shows it to read the correct temp now. Unfortunately, after I did this, I tried to start the car again, on cranking I...