Syvecs Forums

Indeed, there’s a Bosch 54mm available but the custom manifold needed is a quite a bit of cash. On the to do list.

Blades 49mm

Syvecs base map caped at 75, I added 5%. Don’t want to burn it out. Anyway, not seeing much tpsDTR improvement anyway by pushing boundary of duty limits so blade is going as fast as its capable at 80%

So the finding is the DbW on the GR yaris simply can not respond fast enough above a certain DbW blipTarget from closed throttle. I can get my sequential box downshifts nice and smooth with no clutch up to around 3000 rpm, which demands about 35% tps depending on gear. above 3000 it gets harsh as sh...

One thing I realised through testing is roll on rate has almost no effect, right from 0.01% to 100%.

Blip targetMult has a massive impact on how fast the blip comes in and has a large impact on smoothness of downshift.

Continuing the testing…..

Hi, Torque reductions during blip are coming from post downshift rev limit during blip active, after down shift they are ALS settings for burble. I’ll try turn off ALS to see if it makes a difference. Blip targets are small but feel smoother with smaller targets as If I try more blip target, blips g...

logs of downshifting from 6 to 1.
This is closed loop. No other parameters ending blip. Rev limit active on blip.

Apologies, meant downshifts. Up shifts are great. I’ll post up logs but blips look like they are coming on at the right time.

Setting up a GR Yaris with sequential, all is good but downshifts are very harsh at high rpm. Tried closed loop on barrel%, request ends cut like in the syvecs help video, open loop etc. its downshifts nice at low rpm but very harsh at high. Open loop with longer blip times seem best. TPs bliptarget...

I have a TinyD on my N54 plug and play and it does the same thing with voltage warning. Interestingly, I also have a TIny on my Syvecs equipped GR Yaris, and that does not do it. Both have the same firmware.

Try setting your start finish once you create the track, the going to session / beacons and tell it to use pre defined beacons. Lap mode should then work.